<Vendor Amusements>

Zymeta Ongoing Repair Issues (Read 129 times)

Forum God YaBB Administrator	Zymeta Ongoing Repair Issues on: 02/03/10 at 09:51:18
Posts: 19355 Gender:	I will be adding to this as time goes on. There are some known issues, which I have solutions for.

Back to top	Comments, editorials, etc. posted on this website or message boards are not necessarily those of Vendor Amusements, but solely of the webmaster.
		IP Logged

Forum God YaBB Administrator	Motherboard Issues Reply #1 - on: 02/04/10 at 17:04:34
Posts: 19355 Gender:	The version 3 Zymeta shipped with a ASUS A7N8X-VM400 motherboard. I have discovered there are two different revisions of this board, one of which is prone to blown caps. This sticker, located on the top of the parallel port, distinguishes between the two. GOOD ONE This is the rev that used Nichicon, TMZ and a few KZE caps. I don't believe I have seen any of this rev with blown caps. Multimedia File Viewing and Clickable Links are available for Registered Members only!! You need to Login or Register!! BAD ONE Notice it says TVOUT near the end of the model sticker. This is the rev that used all KZE/KZG caps. Most of the 3300uF caps blow, as well as some 1000uF caps. Regardless, there are 26 capacitors that should be replaced. Multimedia File Viewing and Clickable Links are available for Registered Members only!! You need to Login or Register!!

Back to top	Comments, editorials, etc. posted on this website or message boards are not necessarily those of Vendor Amusements, but solely of the webmaster.
		IP Logged